WASHER NOZZLE(for Rear Side) ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT REAR WASHER NOZZLE


    1. With the engine switch turned to ON, check that the center stream of washer fluid sprays on the back door glass within the hatched area shown in the illustration.

      OK
      Washer fluid hits the back door glass in the area shown in the illustration.

      If the result is not as specified, adjust the rear washer nozzle sub-assembly.

      A01HIVIC01
      B008HF7 Standard Clearance - -
      Standard
      Area Specified Condition Area Specified Condition
      A 57 mm (2.2441 in.) B 19 mm (0.7480 in.)
      C 48 mm (1.8898 in.) D 115 mm (4.5276 in.)
      E 44 mm (1.7323 in.) F 155 mm (6.1024 in.)
      G 182 mm (7.1653 in.) H 48 mm (1.8898 in.)

      Note

      If the result is not as specified, adjust the rear washer nozzle.

      Click here