REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY


  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01HGHMN08

      Using SST, hold the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      The part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A01HGCH

      Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the front drive plate spacer.

  3. REMOVE REAR ENGINE OIL SEAL


    1. A01HF41C17
      *a Cut Position
      *b Protective Tape

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.

      Note


      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the rear engine oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.