FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed or replaced during the front seat inner belt assembly LH removal / installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-collision system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH


    1. B0024BF

      Remove the band in the position shown in the illustration.

    2. B0025LL

      Detach the wire harness clamp and connector clamp.

    3. B0024GHC04
      B0069FO Remove in this Direction

      Open the cover as shown in the illustration.

    4. B0025ZC

      Detach the wire harness clamp and remove the nut and front seat inner belt assembly LH.

    5. Remove the front seat belt anchor plate.

  3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH


    1. B0027Z3

      Detach the wire harness clamp and connector clamp.

    2. B0025Q0C01
      B0069FO Remove in this Direction

      Open the cover as shown in the illustration.

    3. B00264U

      Detach the wire harness clamp and remove the nut and front seat inner belt assembly RH.

    4. Remove the front seat belt anchor plate.