OUTER REAR VIEW MIRROR GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR LH


    1. Push the upper part of the mirror surface and tilt it.

    2. B005V6XC01
      B005RAJC55 Push
      B006GBM Protective Tape

      Apply protective tape as shown in the illustration.

    3. B005QNTC01
      B006DHE Push
      B006GBM Protective Tape

      Push down the lower part of the mirror surface and tilt it.

    4. Apply protective tape as shown in the illustration.

    5. B005U98C02
      B006DHE Remove in this Direction
      B006GBM Protective Tape

      Push the upper part of the mirror surface and tilt it.

    6. Using moulding remover D, detach the claw.

    7. B005RSYC02
      B006DHE Remove in this Direction
      B006GBM Protective Tape

      Push down the lower part of the mirror surface and tilt it.

      Tech Tips

      The claw will reattach if excessive force is applied when pushing down the mirror surface.

    8. Using moulding remover D, detach the claw.

      Note

      Do not forcibly pull on the outer mirror LH as the unit drive may detach, or the mirror surface part may break.

    9. B005W9K

      Detach the clamp.

    10. Disconnect the 2 mirror heater connectors.

      Note


      • Do not raise the claw higher than is necessary as it will damage the claw of the terminal.

      • If the claw of the connector is damaged, replace the outer mirror LH with a new one.

      • If there is damage to the wire harness or an open circuit has occurred, replace the outer rear view mirror assembly LH with a new one.

    11. B005S67

      Detach the clamp.

    12. Disconnect the EC mirror connector.

      Note


      • Do not raise the claw higher than is necessary as it will damage the claw of the connector.

      • If the claw of the connector is damaged, replace the outer mirror LH with a new one.

      • If there is damage to the wire harness or an open circuit has occurred, replace the outer rear view mirror assembly LH with a new one.

    13. B005R2K

      w/ Blind Spot Monitor System:


      1. Detach the clamp.

      2. Disconnect the blind spot monitor indicator connector to remove the outer mirror LH.

        Note


        • Do not raise the claw higher than is necessary as it will damage the claw of the connector.

        • If the claw of the connector is damaged, replace the outer rear view mirror assembly LH with a new one.

        • If there is damage to the wire harness or an open circuit has occurred, replace the outer rear view mirror assembly LH with a new one.