ENGINE IMMOBILISER SYSTEM, Diagnostic DTC:B2797

DTC Code DTC Name
B2797 Communication Malfunction No. 1

DESCRIPTION

This DTC is stored when a communication error occurs between the transponder key amplifier and transponder key ECU assembly. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communication line.

DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B2797 A key with a BCC malfunction is inserted into the ignition key cylinder (1 trip detection logic*).
  • Key

  • Harness or connector

  • Transponder key amplifier

  • Transponder key ECU assembly

Insert the key into the ignition key cylinder

Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started. -
Related Data List and Active Test
DTC Code Data List and Active Test
B2797 BCC Malfunction

WIRING DIAGRAM

A01DXQ2E02

INSPECTION PROCEDURE

Note


  • When replacing the transponder key ECU assembly, refer to the Service Bulletin.

  • After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

PROCEDURE


  1. CHECK KEY


    1. A01E1W0

      Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether a key ring is in contact with the key grip.

      Result
      Result Proceed to
      Key is near other keys and/or key ring is in contact with key grip A
      Key is not near other keys and/or key ring is not in contact with key grip B

    B
    A
  2. CHECK FOR DTC


    1. Separate the keys from each other and/or remove the key ring.

    2. Clear the DTC Click here.

    3. Insert a key into the ignition key cylinder, and then remove it. Repeat this for all the other keys.

    4. Check that no code is output.

      OK
      DTC B2797 is not output.

    NG
    OK
  3. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)


    1. Disconnect the T21 transponder key ECU assembly connector.

    2. Disconnect the T20 transponder key amplifier connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      T21-15 (CODE) - T20-4 (CODE) Always Below 1 Ω

    NG
    OK
  4. CHECK TRANSPONDER KEY ECU ASSEMBLY


    1. Using an oscilloscope or the intelligent tester, check for noise in the waveform between the terminals of the T20 transponder key amplifier connector and T21 transponder key ECU assembly connector.

      A01E2IIE04
      Text in Illustration
      *a

      Component with harness connected

      (Transponder Key Amplifier)

      *b

      Component with harness connected

      (Transponder Key ECU Assembly)

      *c Noise should not appear - -
      Measurement Condition
      Item Content
      Tester Connection T21-15 (CODE) - T20-4 (CODE)
      Tool Setting 5 V/DIV., 20 msec./DIV.
      Condition Key inserted in ignition key cylinder
      OK
      No noise is present (see illustration).

    NG
    OK
  5. REPLACE TRANSPONDER KEY AMPLIFIER (OPERATION)


    1. Temporally replace the transponder key amplifier with a new or normally functioning one Click here.


    NEXT
  6. CHECK WHETHER ENGINE STARTS


    1. Check that the engine starts normally.

      OK
      Engine starts.

    NG
    OK