OCCUPANT CLASSIFICATION SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Occupant Detection / Data List.

    6. Check the values by referring to the table below.

      Body Electrical > Occupant Detection > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      IG Switch

      Ignition switch condition

      ON/OFF

      ON: Ignition switch ON

      OFF: Ignition switch off

      "OFF" is also displayed for this item when the ignition switch is ACC.

      Passenger Buckle SW

      Front seat belt assembly RH buckle switch

      Set, Unset or NG

      Set: The front seat belt assembly RH is fastened

      Unset: The front seat belt assembly RH is not fastened

      NG: Data is not determined

      -

      Passenger Classification

      Front passenger classification

      AM50/AF05/Child/CRS/OFF

      AM50: Adult is seated

      AF05: Adult is seated

      Child: Child is seated

      CRS: Child restraint system is installed

      OFF: Vacant

      -

      Sensor Range Info

      Sensor range information

      OK/NG

      OK: The value of an occupant detection sensor is within the range

      NG: The value of an occupant detection sensor is over the range

      As sensor range is not set, OK is always displayed

      FL Sensor Range Info

      Front left sensor range information

      OK

      OK

      As front left sensor range is not set, OK is always displayed

      RL Sensor Range Info

      Rear left sensor range information

      OK

      OK

      As rear left sensor range is not set, OK is always displayed

      FL Sensor Voltage

      Front left sensor voltage

      Min.: 0 V

      Max.: 19.8 V

      0 to 5 V

      -

      RL Sensor Voltage

      Rear left sensor voltage

      Min.: 0 V

      Max.: 19.8 V

      0 to 5 V

      -

      FL Sensor Weight Info

      Front left sensor weight information

      Min.: -10 kg (-22.0 lb)

      Max.: 20 kg (44.1 lb)

      -10 to 20 kg (-22.0 to 44.1 lb)

      -

      RL Sensor Weight Info

      Rear left sensor weight information

      Min.: -10 kg (-22.0 lb)

      Max.: 30 kg (66.1 lb)

      -10 to 30 kg (-22.0 to 66.1 lb)

      -

      Total Weight Information

      Total weight information

      Min.: -40 kg (-88.2 lb)

      Max.: 100 kg (220.5 lb)

      -40 to 100 kg (-88.2 to 220.5 lb)

      -

      Number of Present DTC

      Number of present DTCs recorded

      Min.: 0, Max.: 255

      0

      -

      Number of Past DTC

      Number of past DTCs recorded

      Min.: 0, Max.: 255

      0

      -