CAMSHAFT OIL CONTROL VALVE(for Bank 1) REMOVAL

PROCEDURE

1. REMOVE V-BANK COVER SUB-ASSEMBLY

   Click here

2. REMOVE RADIATOR COVER PLATE

   Click here

3. REMOVE UPPER RADIATOR SUPPORT SEAL

   Click here

4. REMOVE LOWER RADIATOR AIR DEFLECTOR

   Click here

5. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1)

   Click here

6. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side of Bank 1)

   Click here

7. SET NO. 1 CYLINDER TO TDC/COMPRESSION

   
   
   1. 

      *a	Timing Mark
      *b	Timing Mark (Cutout)

      Turn the crankshaft pulley assembly clockwise until its timing mark (cutout) is aligned with the timing mark on the timing chain cover assembly as shown in the illustration.

   2. Check that the cutout of the camshaft timing gear assembly is at the top.

      
      
      1. 

         *a	Correct
         *b	Incorrect
         *c	Cutout
         *d	Up

         for Intake Side:

         Tech Tips

         
         

         • If the cutout of the camshaft timing gear assembly (for Intake side) is not at the top, turn the crankshaft 360° clockwise and align the timing mark (cutout) of the crankshaft pulley with the timing mark on the timing chain cover assembly again.

      2. 

         *a	Correct
         *b	Incorrect
         *c	Cutout
         *d	Up

         for Exhaust Side:

         Tech Tips

         
         

         • If the cutout of the camshaft timing gear assembly (for exhaust side) is not at the top, turn the crankshaft 360° clockwise and align the timing mark (cutout) of the crankshaft pulley with the timing mark on the timing chain cover assembly again.

8. REMOVE CAMSHAFT TIMING GEAR BOLT (for Intake Side of Bank 1)

   
   

   1. 

      Using SST, hold the crankshaft pulley assembly.

      SST

      09213-54015   ( 91651-60855 )

      09330-00021

   2. 

      Remove the camshaft timing gear bolt.

      Note

      
      

      • If the camshaft timing gear bolt has been struck or dropped, replace it.

      • Do not turn the crankshaft pulley after removing the camshaft timing gear bolt.

9. REMOVE CAMSHAFT TIMING GEAR BOLT (for Exhaust Side of Bank 1)

   
   

   1. 

      Using SST, hold the crankshaft pulley assembly.

      SST

      09213-54015   ( 91651-60855 )

      09330-00021

   2. 

      Remove the camshaft timing gear bolt.

      Note

      
      

      • If the camshaft timing gear bolt has been struck or dropped, replace it.

      • Do not turn the crankshaft pulley after removing the camshaft timing gear bolt.