KNOCK SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Knock control sensor Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE FUEL INJECTOR ASSEMBLY (for Direct Injection)

    Click here

  2. REMOVE KNOCK CONTROL SENSOR


    1. B005STO

      Disconnect the 2 knock control sensor connectors.

    2. Remove the 2 bolts and 2 knock control sensors.

      Note

      If a knock control sensor has been struck or dropped, replace it.