NAVIGATION ECU INSTALLATION

PROCEDURE

1. PRECAUTION

   Note

   
   

   • When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

   
   

   • A communication malfunction DTC may be stored.

   • The radio and display receiver assembly or navigation ECU may not operate normally.

   • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.

2. INSTALL NAVIGATION ECU

3. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY

4. INSTALL NO. 2 RADIO RECEIVER BRACKET

   Click here

5. INSTALL NO. 1 RADIO RECEIVER BRACKET

   Click here

6. INSTALL NO. 1 NAVIGATION WIRE

   
   

   1. Connect the 3 connectors to install the No. 1 navigation wire.

7. INSTALL MULTI-MEDIA MODULE WIRE

   Click here

8. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET

   Click here

9. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

11. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

12. INSTALL NO. 1 METER HOOD CLUSTER

    Click here

13. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Click here