CENTER AIRBAG SENSOR ASSEMBLY ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures of the airbag sensor assembly.

PROCEDURE

  1. INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

    1. Perform a diagnostic system check.

      Click here

  2. INSPECT AIRBAG SENSOR ASSEMBLY (Vehicle Involved in Collision and Airbag not Deployed)

    1. Perform a diagnostic system check.

      Click here

    2. Visually check for defects with the airbag sensor assembly installed on the vehicle.

      1. The defects are as follows:

        • Cracks on the sensor housing

        • Dents on the sensor housing

        • Chips on the sensor housing

        • Cracks or other damage to the connector

        • Peeling of the label

        OK

        No defects are found.

        Tip:

        If any of the defects is found, replace the airbag sensor assembly with a new one.

  3. INSPECT AIRBAG SENSOR ASSEMBLY (Vehicle Involved in Collision and Airbag is Deployed)

    1. Replace the airbag sensor assembly.

      Tip:

      The airbag sensor assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.