FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to the lip of a new timing chain case oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the timing chain case oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Install the timing chain case oil seal to SST.

      SST
      09223-51010
    3. B0069OSC02
      *1 Crankshaft Pulley Set Bolt
      *2 Timing Chain or Belt Cover Sub-assembly
      *3 Timing Chain Case Oil Seal
      *a Oil Seal Protrusion Height

      Set SST and the crankshaft pulley set bolt as shown in the illustration.

      Tech Tips

      Make sure to leave the crankshaft pulley set bolt screwed into the crankshaft by 2 or 3 threads.

    4. Using SST and the crankshaft pulley set bolt, evenly tap in the timing chain case oil seal until its surface is flush with the end face of the timing chain or belt cover sub-assembly.

      Oil Seal Protrusion Height
      0 to 0.5 mm (0 to 0.0197 in.)

      Note


      • Do not tap the timing chain case oil seal at an angle.

      • Keep the lip free of foreign matter.

  2. INSTALL CRANKSHAFT PULLEY


    1. B006F9SC02
      *a Hold
      B006AHR Turn

      Align the crankshaft timing gear key with the key groove of the crankshaft pulley, and slide on the crankshaft pulley.

    2. Using SST, install the crankshaft pulley set bolt.

      SST
      09213-54015   ( 09213-70020 )
      09330-00021
      Torque:
      365 N*m  { 3722 kgf*cm, 269 ft.*lbf }

  3. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY


    1. B006GEJ

      Install the crankshaft damper sub-assembly with the 2 bolts.

      Torque:
      24 N*m  { 245 kgf*cm, 18 ft.*lbf }
      Bolt Length
      Item Length
      Bolt 20 mm (0.787 in.)

  4. INSTALL CRANKSHAFT PULLEY COVER


    1. B006AZLC02
      *1 Crankshaft Pulley Cover
      *a Paint Mark
      B006EC9 Front Side

      Install the crankshaft pulley cover with the 2 bolts.

      Torque:
      24 N*m  { 245 kgf*cm, 18 ft.*lbf }
      Bolt Length
      Item Length
      Bolt 30 mm (1.18 in.)

      Note

      Install so the paint mark is facing the front side.

  5. INSTALL FAN AND GENERATOR V BELT

    Click here

  6. ADD ENGINE OIL

    Click here

  7. INSPECT ENGINE OIL LEVEL

    Click here

  8. INSPECT FOR OIL LEAK

    Click here