| DTC Code | DTC Name |
|---|---|
| P0500 | Vehicle Speed Sensor Malfunction |
DESCRIPTION
The speed sensor installed on the wheels outputs wheel speed pulse signals which are then converted to vehicle speed pulse signals by the skid control ECU (brake actuator assembly). These pulse signals are then output to the combination meter assembly as vehicle speed signals and then input to the ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0500 | Vehicle Speed Sensor Malfunction | The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while the cruise control is in operation |
|
*1: w/ Vehicle Stability Control System
*2: w/o Vehicle Stability Control System
CAUTION / NOTICE / HINT
This DTC may be output by the SFI system at the same time. In that case, perform troubleshooting for the SFI system first*1.
This DTC may be output by the ECD system at the same time. In that case, perform troubleshooting for the ECD system first*2.
*1: for 1GR-FE, 2TR-FE
*2: for 1KD-FTV, 1GD-FTV, 2GD-FTV
PROCEDURE
CHECK FOR DTCs
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
Tech Tips
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
Check for DTCs.
| Result | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| A |
|
USE SIMULATION METHOD TO CHECK Click here |
| B |
|
GO TO SFI SYSTEM for 1GR-FE: Click here |
| C |
|
GO TO ECD SYSTEM for 1KD-FTV: Click here |