STEERING GEAR(for AWD) COMPONENTS
ILLUSTRATION
| *1 | LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY | *2 | NEGATIVE BATTERY TERMINAL |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | FRONT SUSPENSION MEMBER BRACE | *2 | NO. 1 ENGINE UNDER COVER ASSEMBLY |
| *3 | NO. 2 ENGINE UNDER COVER ASSEMBLY | *4 | STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY |
| *5 | TRANSMISSION UNDER COVER | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| ★ | Precoated part | ● | Non-reusable part |
ILLUSTRATION
| *1 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY | *2 | RACK AND PINION POWER STEERING GEAR ASSEMBLY |
| *3 | ENGINE ROOM MAIN WIRE | *4 | FRONT FRAME ASSEMBLY |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with SST and union nut wrench | ● | Non-reusable part |
ILLUSTRATION
| *1 | NO. 1 STEERING RACK BOOT | *2 | NO. 2 STEERING RACK BOOT |
| *3 | NO. 2 STEERING RACK BOOT CLAMP | *4 | RACK AND PINION POWER STEERING GEAR ASSEMBLY |
| *5 | STEERING RACK BOOT CLIP | *6 | TIE ROD ASSEMBLY LH |
| *7 | TIE ROD ASSEMBLY RH | *8 | WIRE HARNESS CLAMP BRACKET |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part |  |
Lithium soap base glycol grease |