AUDIO AND VISUAL SYSTEM (for Radio and Display Type) DTC CHECK / CLEAR


  1. START DIAGNOSTIC MODE

    Tech Tips


    • Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.

    • If the system cannot enter the diagnostic mode, replace the radio and display receiver assembly Click here.


    1. Start the engine.

    2. A01DZ7RE01
      Text in Illustration
      *a Example

      While pressing and holding the "AUDIO" or "MEDIA" switch, operate the light control switch: off → turn on → turn off → turn on → turn off → turn on → turn off.

    3. A01E1D9

      Diagnostic mode starts and the "Service Menu" screen is displayed.

  2. FINISH DIAGNOSTIC MODE


    1. There are 2 methods to end diagnostic mode. Use one of them.


      1. Turn the ignition switch off.

      2. Press and hold the "AUDIO" or "MEDIA" switch for 3 seconds.

  3. FAILURE DIAGNOSIS


    1. A01DVTP

      Touch the "Failure Diagnosis" button on the "Service Menu" screen.

    2. A01DZ5Q

      The "Failure Diagnosis" screen is displayed.

  4. SYSTEM CHECK


    1. A01DVAM

      Touch the "System Check" button on the "Failure Diagnosis" screen.

    2. A01E2OJ

      The "System Check Mode" screen is displayed.

  5. CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN)


    1. Read the system check result.

    2. A01DV2EE01
      Text in Illustration
      *a Check Result

      If the check result is "DETAIL", touch the displayed check result.

    3. A01E2LQE01
      Text in Illustration
      *a Diagnostic Code

      View the results on the "Unit Check Mode" screen and record them.

    4. When proceeding to view the results of another device, touch the "Back" button to return to the "System Check Mode" screen.

      Tech Tips

      To check the other items, repeat this procedure from the first step.

  6. DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN)


    1. Clear DTC


      1. A01E1TI

        Touch the "Code CLR" button for 3 seconds.

      2. Confirm that the check results are cleared.

        Tech Tips


        • To clear the DTC for a specific device, clear the DTC using the "Unit Check Mode" screen.

        • When clearing a DTC using the "Unit Check Mode" screen, touch the "Code CLR" button for 3 seconds.

    2. Recheck


      1. A01E129

        Touch the "Recheck" button.

      2. A01DW2W

        Confirm that all check results are "OK" when the check results are displayed. If a result other than "OK" is displayed, troubleshoot again.

        Tech Tips

        When a DTC is cleared using the "Unit Check Mode" screen, touch the "Back" button to return to the "System Check Mode" screen and perform this operation.