VEHICLE PROXIMITY NOTIFICATION SYSTEM, Diagnostic DTC:B1350

DTC Code DTC Name
B1350 Speaker Circuit

DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.

This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit.

DTC No. DTC Detection Condition Trouble Area
B1350

Either of the following conditions is met:


  • When sound output voltage is being monitored by the ECU, with the power switch on (IG), battery voltage 10 V or more, and warning sound being produced, a speaker circuit short condition continues for 1 second or more.

  • When sound output voltage is being monitored by the ECU, with the power switch on (IG) and warning sound not being produced, a speaker circuit open condition continues for 5 seconds or more.


  • Vehicle approaching speaker controller

  • Vehicle approaching speaker assembly

  • Harness or connector between vehicle approaching speaker controller and vehicle approaching speaker assembly

WIRING DIAGRAM

A005A22E20
*a SP+
*b SP-
*c Vehicle Approaching Speaker Controller
*d Vehicle Approaching Speaker Assembly

PROCEDURE


  1. INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY


    1. Remove the vehicle approaching speaker assembly Click here.

    2. Inspect the vehicle approaching speaker assembly Click here.


    NG
    OK
  2. CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER ASSEMBLY)


    1. Disconnect the L130 vehicle approaching speaker controller connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L130-3 (SP+) - A69-1 (+) Always Below 1 Ω
      L130-8 (SP-) - A69-2 (-) Always Below 1 Ω
      L130-3 (SP+) or A69-1 (+) - Body ground Always 10 kΩ or higher
      L130-8 (SP-) or A69-2 (-) - Body ground Always 10 kΩ or higher

    OK
    NG