AIRBAG CUT-OFF SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the front passenger side of RHD and LHD vehicles.

  • The procedures listed below are for the front passenger side of LHD vehicles.

PROCEDURE

  1. INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

    1. Connect the connector.

    2. Attach the 2 claws to install the airbag cut off switch cylinder sub-assembly.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  4. CHECK SRS WARNING LIGHT

    Click here