FRONT DOOR BELT MOULDING INSTALLATION

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY


    1. A005BIW

      Engage the 7 claws to install the front door belt moulding assembly.

  3. INSTALL FRONT DOOR GLASS RUN

    Click here

  4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  6. INSTALL FRONT DOOR TRIM BRACKET

    Click here

  7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  8. INSTALL DOOR ARMREST COVER

    Click here

  9. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  13. INSTALL DECK FLOOR BOX RH

    Click here

  14. INSTALL REAR DECK FLOOR BOX

    Click here

  15. INSTALL NO. 1 DECK BOARD

    Click here

  16. INSTALL NO. 2 DECK BOARD

    Click here

  17. INSTALL DECK BOARD ASSEMBLY

    Click here

  18. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  19. INSPECT POWER WINDOW OPERATION

    Click here