DESCRIPTION
The SRS warning light is located on the combination meter. When the SRS is normal, the SRS warning light illuminates for approximately 6 seconds after the ignition switch is turned from OFF to ON, and then turns OFF automatically. If there is a malfunction in the SRS, the SRS warning light illuminates to inform the driver. When terminals TC and CG of the DLC3 are connected, the DTCs are communicated through SRS warning light blinking patterns.
WIRING DIAGRAM
Refer to "SRS Warning Light Remains on" Click here.
INSPECTION PROCEDURE
CAUTION:
Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment.
Turn the ignition switch OFF.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Disconnect the connector from the center airbag sensor.
Disconnect the connector from the steering pad.
PROCEDURE
CHECK CONNECTION OF CONNECTORS
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor and combination meter.
| OK |
|---|
| Connectors are connected. |
| NG |
|
CONNECT CONNECTORS |
| OK |
|
CHECK COMBINATION METER ASSEMBLY
Disconnect the C25 meter connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector.
| Standard voltage | ||||
|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS AND CONNECTOR |
| OK |
|
CHECK SRS WARNING LIGHT OPERATION
Replace the center airbag sensor.
Check that the SRS warning light illuminates normally.
| OK |
|---|
| SRS warning light illuminates normally. |
| NG |
|
REPLACE COMBINATION METER ASSEMBLY |
| OK |
|
REPLACE CENTER AIRBAG SENSOR ASSEMBLY
| NG |
|
REPLACE COMBINATION METER ASSEMBLY |
| OK |
|
END