GENERATOR INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   1. Install the wire harness clamp bracket with the bolt.

      7.7 N*m

      79 kgf*cm

      68 in.*lbf

   2. Temporarily install the generator assembly and No. 2 generator bracket with the 3 bolts.

   3. 

      	Bolt A
      	Bolt B

      Tighten the 3 bolts in the order shown in the illustration to install the generator assembly and No. 2 generator bracket.

      for bolt A

      43 N*m

      438 kgf*cm

      32 ft.*lbf

      for bolt B

      25 N*m

      255 kgf*cm

      18 ft.*lbf

   4. Connect the wire harness to terminal B with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   5. Install the terminal cap.

   6. Connect the connector and attach the wire harness clamp.

2. INSTALL V-RIBBED BELT

   Click here

3. INSPECT V-RIBBED BELT

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick here

5. INSTALL REAR ENGINE UNDER COVER RH

   Click here

6. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

7. INSTALL NO. 2 CYLINDER HEAD COVER

   Click here