DYNAMIC REAR STEERING SYSTEM, Diagnostic DTC:C1B15

DTC Code DTC Name
C1B15 Motor Rotation Angle Malfunction

DESCRIPTION

When the DRS ECU (rear steering control ECU) detects a problem with motor operation, DTC C1B15 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
C1B15 Motor Rotation Angle Malfunction After turning the engine switch on (IG), the motor does not operate according to the command from the ECU. Rear steering link assembly Comes on Engine switch on (IG) again

CAUTION / NOTICE / HINT

Note

If the rear steering link assembly or the rear suspension is removed and installed, replaced, or adjusted, after performing actuator calibration value initialization, perform neutral position memorization and motor rotation angle sensor calibration.

Click here

PROCEDURE


  1. CHECK FOR DTC


    1. Check for DTCs.

      Click here


      Chassis > DRS > Trouble Codes
      Result
      Result Proceed to
      DTC C1B15 is output as a past DTC A
      DTC C1B15 is output as a current DTC B

    B

    REPLACE REAR STEERING LINK ASSEMBLY Click here

    A

  2. PERFORM ACTUATOR FORCED ACTIVATION


    1. Perform actuator forced activation and confirm the operation of the rear steering.

      Click here

      Result
      Result Proceed to
      The rear wheels do not turn or only turn in one direction A
      The rear wheels turn to the left and right B

    A

    REPLACE REAR STEERING LINK ASSEMBLY Click here

    B

    USE SIMULATION METHOD TO CHECK Click here