РЕЛЕ ВКЛЮЧЕНИЯ СВЕЧЕЙ НАКАЛИВАНИЯ ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE GLOW RELAY (Marking: GLOW)


    1. Remove the engine room relay block cover.

    2. Remove the glow relay from the engine room relay block.

  3. INSPECT GLOW RELAY


    1. A01DY9ZE03

      Measure the resistance of the glow relay.

      Standard resistance
      Tester Connection Specified Condition
      3 - 5 10 kΩ or higher
      3 - 5

      Below 1 Ω

      (when battery voltage is applied to terminals 1 and 2)

      If the result is not as specified, replace the relay.

  4. INSTALL GLOW RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  6. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.