REAR LIGHT ASSEMBLY(except Sedan) INSPECTION

PROCEDURE

1. INSPECT REAR LIGHT ASSEMBLY LH

   1. 

      *a	Component without harness connected (Rear Light Assembly LH)

      Apply battery voltage to the rear light assembly LH and check that the light comes on.

      OK

      Condition	Specified Condition
      Battery positive (+) → Terminal 2 (B) Battery negative (-) → Terminal 3 (E)	The back-up light comes on

      If the result is not as specified, replace the bulb or rear light socket and wire LH.

   2. Apply battery voltage to the rear light assembly LH and check that the light comes on.

      OK

      Condition	Specified Condition
      Battery positive (+) → Terminal 1 (B) Battery negative (-) → Terminal 3 (E)	The taillight comes on
      Battery positive (+) → Terminal 4 (B) Battery negative (-) → Terminal 3 (E)	The rear fog light comes on*

      • *: for LHD

      If the result is not as specified, replace the rear light lens and body LH or rear light socket and wire LH.

2. INSPECT REAR LIGHT ASSEMBLY RH

   1. 

      *a	Component without harness connected (Rear Light Assembly RH)

      Apply battery voltage to the rear light assembly RH and check that the light comes on.

      OK

      Condition	Specified Condition
      Battery positive (+) → Terminal 2 (B) Battery negative (-) → Terminal 3 (E)	The back-up light comes on

      If the result is not as specified, replace the bulb or rear light socket and wire RH.

   2. Apply battery voltage to the rear light assembly RH and check that the light comes on.

      OK

      Condition	Specified Condition
      Battery positive (+) → Terminal 1 (B) Battery negative (-) → Terminal 3 (E)	The taillight comes on
      Battery positive (+) → Terminal 4 (B) Battery negative (-) → Terminal 3 (E)	The rear fog light comes on*

      • *: for RHD

      If the result is not as specified, replace the rear light lens and body RH or rear light socket and wire RH.