| DTC Code | DTC Name |
|---|---|
| P0A37-260 | Generator Temperature Sensor Circuit Range / Performance |
| P0A3A-258 | Generator Temperature Sensor Circuit Intermittent |
DESCRIPTION
The resistance of the thermistor built into the generator temperature sensor changes in accordance with changes in generator (MG1) temperature. The lower the generator (MG1) temperature, the higher the thermistor resistance. Conversely, the higher the generator (MG1) temperature, the lower the resistance.
| *1 | Resistance (kΩ) |
| *2 | Temperature (°C (°F )) |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P0A37-260 | Generator Temperature Sensor Circuit Range / Performance | Generator temperature sensor output does not increase in which the value should increase, or output does not decrease under conditions in which the value should decrease. (1 trip detection logic) |
Hybrid vehicle transmission assembly (Generator temperature sensor) | Does not come on | Master Warning Light: Comes on |
| P0A3A-258 | Generator Temperature Sensor Circuit Intermittent | Sudden change in generator temperature sensor output or hunting Unusual sudden change in generator temperature sensor output occurs and offset condition continues for a certain period of time, or unusual change in motor temperature sensor output occurs repeatedly. (1 trip detection logic) |
Hybrid vehicle transmission assembly (Generator temperature sensor) | Does not come on | Master Warning Light: Comes on |
| DTC No. | Data List |
|---|---|
| P0A37-260 | Motor Temp No2 |
| P0A3A-258 |
CAUTION / NOTICE / HINT
Tech Tips
If DTC P0A37-260 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
Drive the vehicle (stop and go driving) on urban roads for approximately 5 minutes. If the Data List item "Motor Temp No2" shows both increases and decreases in temperature, suspected areas indicated by this DTC are not malfunctioning.
If DTC P0A3A-258 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
Turn the power switch on (READY) and wait for 30 seconds or more.
Drive the vehicle for approximately 5 minutes according to the freeze frame data items "Vehicle Spd", "Inverter Coolant Water Temperature", "Motor Temp No1" and "Motor Temp No2".
PROCEDURE
REPLACE HYBRID VEHICLE TRANSMISSION ASSEMBLY
Tech Tips
The generator temperature sensor is not available as a supply part. If it requires replacement, replace the hybrid vehicle transmission assembly.
| Result | ||
|---|---|---|
|
| NEXT |
|
COMPLETED |