VALVE BODY ASSEMBLY INSTALLATION


  1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

    A01DVXSE04
    A01DYJEE01

    1. Install the spring and check ball body.

    2. Insert the pin of the manual valve into the hole of the manual valve lever.

    3. A01E2JRE01

      Install the transmission valve body with the 19 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      36 mm (1.42 in.) for bolt A

      25 mm (0.984 in.) for bolt B

    4. Install the detent spring and detent spring cover with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. CONNECT TRANSMISSION WIRE

    A01DYKME02

    1. Connect the 7 connectors to the solenoid valves.

    2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

      Torque:
      for bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      for bolt B
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      12 mm (0.472 in.) for bolt A

      36 mm (1.42 in.) for bolt B

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01DUXAE01

    1. Coat a new O-ring with ATF and install it to the oil strainer.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01E1YUE01

    Tech Tips

    Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


    1. Install a new gasket and the oil pan with the 20 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

  5. INSTALL NO. 1 ENGINE MOUNTING INSULATOR REAR (for 1KD-FTV)

    A01DVPCE01

    1. Install the engine mounting insulator to the transmission with the 4 bolts.

      Torque:
      47 N*m  { 479 kgf*cm, 35 ft.*lbf }

  6. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for 1KD-FTV)

    A01E2FL

    1. Install the frame crossmember to the engine mounting insulator with the 4 set bolts.

      Torque:
      27 N*m  { 275 kgf*cm, 20 ft.*lbf }

    2. Connect the ends of the frame crossmember to the vehicle with the 4 bolts and 4 nuts.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.

  8. PERFORM INITIALIZATION


    1. Perform initialization Click here.

  9. ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid Click here.