REAR SEAT OUTER BELT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE REAR SEAT CUSHION ASSEMBLY LH (for Extra Cab)


    1. A01DXC8

      Operate the rear seat cushion lock hook release lever and pull up the rear seat cushion assembly LH to detach the hook.

      Text in Illustration
      A01E2TX Pull Up
      A01DZ8Z Release
    2. A01E1XM

      Detach the 2 hooks and rear seat cushion assembly LH.

  3. REMOVE REAR SEAT CUSHION ASSEMBLY RH (for Extra Cab)

    Tech Tips

    Use the same procedures described for the LH side.

  4. REMOVE REAR SEAT ASSEMBLY (for Double Cab)


    1. Remove the rear seat assembly Click here.

  5. REMOVE QUARTER INSIDE TRIM BOARD LH (for Extra Cab)

    A01DV9UE03

    1. Remove the bolt and anchor.

    2. A01DZ3NE01

      Remove the bolt and rear No. 1 seat belt anchor.

    3. Remove quarter inside trim board Click here.

  6. REMOVE REAR SEAT ASSEMBLY (for Double Cab)

    A01DW3P

    1. Pull the rear seat hinge cover LH to detach the 2 claws.

      Text in Illustration
      A01E2TX Pull
      A01DZ8Z Pull Up

    2. Pull up the rear seat hinge cover LH to detach the guide and remove the rear seat hinge cover LH.

  7. REMOVE REAR DOOR SCUFF PLATE LH (for Double Cab)

    A01E2HT

    1. Detach the claw and 3 clips and remove the lower quarter trim panel.

  8. REMOVE REAR DOOR OPENING TRIM LH (for Double Cab)

  9. REMOVE QUARTER TRIM PANEL LOWER LH (for Double Cab)

    A01E2HT

    1. Detach the claw and 3 clips and remove the lower quarter trim panel.

  10. REMOVE REAR NO. 1 SEAT BELT ASSEMBLY OUTER LH

    A01DUZAE04

    1. Remove the bolt and floor anchor.

    2. A01DWQ1E03

      Using a screwdriver, detach the 2 claws and open the seat belt anchor cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Remove the bolt.

    4. A01E0IHE01

      Remove the bolt and seat belt.