FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE UPPER INSTRUMENT PANEL

    Click here

  4. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    1. Using a screwdriver, pull up and release the connector lock and disconnect the airbag connector.

      Tech Tips


      • Use the same procedure to disconnect the airbag connector on the other side.

      • Tape the screwdriver tip before use.

    2. B008HAPC01
      *1 Connector Lock
      B008HF7 Protective Tape

      Detach the 2 wire harness clamps and remove the No. 2 instrument panel wire.

      CAUTION:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  5. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    CAUTION:

    When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


    1. B008IQ6C01
      *A Front of the Vehicle
      *B Rear of the Vehicle

      Remove the 2 screws.

    2. Insert moulding remover B into the side of the airbag door facing the front of the vehicle and bend moulding remover B to detach the 3 hooks.

    3. Pull the instrument panel passenger airbag assembly in the direction indicated by the arrow shown in the illustration to detach the 3 hooks on the side of the airbag door facing the rear of the vehicle and remove the instrument panel passenger airbag assembly.