DRIVE BELT INSTALLATION

CAUTION / NOTICE / HINT

Tip:

Use a Toyota genuine belt or an equivalent high strength belt when replacing the belt. If a high strength belt is not used, the durability of the belt may be insufficient. A high strength belt is reinforced with an aramid core and is stronger than the other belts with a PET (polyester) or PEN (polyethylene naphthalate) core.

PROCEDURE

  1. INSTALL V-RIBBED BELT

    1. Install the V-ribbed belt as shown in the illustration.

      A200048C01

      *A

      w/o Air Conditioner System

      *B

      w/ Air Conditioner System

      *1

      Tensioner

      *2

      Crankshaft

      *3

      Water Pump

      *4

      Generator

      *5

      A/C Compressor

      -

      -
    2. A205795

      Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.

  2. INSPECT V-RIBBED BELT

    Click here

  3. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  4. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  5. INSTALL NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    1. Install the No. 1 engine under cover with the 6 bolts and 7 clips.

  6. INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    1. Install the No. 1 engine under cover with the 6 bolts and 11 clips.

  7. INSTALL FRONT WHEEL RH

    103 N*m

    1050 kgf*cm

    76 ft.*lbf