REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE

INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
1. Install the rear axle hub and bearing assembly.
  for Torsion Beam Type Suspension:Click here
  for Double Wishbone Type Suspension:Click here
  Tip:
  - The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor is malfunctioning, replace the rear axle hub and bearing assembly.
  - If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
INSPECT REAR AXLE HUB BEARING LOOSENESS

for Torsion Beam Type Suspension:Click here

for Double Wishbone Type Suspension:Click here
INSPECT REAR AXLE HUB RUNOUT

for Torsion Beam Type Suspension:Click here

for Double Wishbone Type Suspension:Click here
CONNECT SKID CONTROL SENSOR WIRE
1. Connect the connector to the rear speed sensor.
INSTALL REAR DISC

Click here
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

for Torsion Beam Type Suspension:Click here

for Double Wishbone Type Suspension:Click here
CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

for Torsion Beam Type Suspension:Click here

for Double Wishbone Type Suspension:Click here
INSTALL PARKING BRAKE LEVER PROTECTOR (for Double Wishbone Type Suspension)

Click here
ADJUST PARKING BRAKE

Click here
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Click here
INSTALL REAR WHEEL

103 N*m

1050 kgf*cm

76 ft.*lbf
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
CHECK FOR SPEED SENSOR SIGNAL

w/o VSC:Click here

w/ VSC:Click here