STARTER(w/o Stop And Start System) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  3. REMOVE NO. 1 ENGINE UNDER COVER

    Click hereClick here

  4. REMOVE FLYWHEEL HOUSING SIDE COVER

    1. A398933C01

      *a

      Protrusion

      Disengage the claw as shown in the illustration to remove the flywheel housing side cover.

  5. REMOVE STARTER ASSEMBLY

    1. A398055

      Disengage the clamp and remove the terminal cap protector from the terminal cap.

    2. A398054

      Disconnect the starter assembly connector.

    3. Open the terminal cap.

    4. Remove the nut and disconnect terminal 30.

    5. Remove the 2 bolts and starter assembly.