POWER WINDOW CONTROL SYSTEM Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch

DTC Code DTC Name
Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch

DESCRIPTION

  • If the manual up/down function does not operate, there may be a malfunction in the power window regulator switch, front passenger side door window regulator, harness or connector.

WIRING DIAGRAM

B225717E10

CAUTION / NOTICE / HINT

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

  1. CHECK LIN COMMUNICATION SYSTEM

    1. Check for LIN communication system DTCs related to the power window control system (Click here).

      OK

      LIN communication system DTCs are not output.

    GO TO LIN COMMUNICATION SYSTEM

    (Click here)

  2. CHECK FOR DTC (B2312)

    1. Check if DTC B2312 is output (Click here).

      OK

      DTC B2312 is not output.

    GO TO DTC B2312

    (Click here)

  3. READ VALUE USING INTELLIGENT TESTER (FRONT PASSENGER SIDE DOOR WINDOW REGULATOR ASSEMBLY)

    1. Use the Data List to check if the front door window regulator is functioning properly (Click here).

      Table 1. P-Door Motor

      Tester Display

      Measurement Item/Range

      Normal Condition

      Diagnostic Note

      P Door P/W Up SW

      Front passenger side power window manual up signal / ON or OFF

      ON: Front passenger side power window manual up switch operated

      OFF: Front passenger side power window switch not operated

      -

      P Door P/W Down SW

      Front passenger side power window manual down signal / ON or OFF

      ON: Front passenger side power window manual down switch operated

      OFF: Front passenger side power window switch not operated

      -

      OK

      Display changes according to operation of power window regulator switch.

      Table 2. Result

      Result

      Proceed to

      OK (for LHD)

      A

      OK (for RHD)

      B

      NG

      C

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY RH

    (Click here)

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH

    (Click here)

  4. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - BODY GROUND)

    1. B216016E04

      Disconnect the J4*1 or K4*2 switch connector.

      • *1: for LHD

      • *2: for RHD

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Table 3. for LHD

      Tester Connection

      Condition

      Specified Condition

      J4-1 (GND) - Body ground

      Always

      Below 1 Ω
      Table 4. for RHD

      Tester Connection

      Condition

      Specified Condition

      K4-1 (GND) - Body ground

      Always

      Below 1 Ω
      Table 5. Text in Illustration

      *1

      for LHD

      *2

      for RHD

      *3

      Front view of wire harness connector

      (to Power Window Regulator Switch)

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  5. CHECK HARNESS AND CONNECTOR (FRONT DOOR WINDOW REGULATOR ASSEMBLY - BATTERY AND BODY GROUND)

    1. B216017E09

      Disconnect the J8*1 or K10*2 regulator connector.

      • *1: for LHD

      • *2: for RHD

    2. Measure the voltage and resistance according to the value(s) in the table below.

      Standard Voltage

      Table 6. for LHD

      Tester Connection

      Condition

      Specified Condition

      J8-2 (B) - Body ground

      Always

      11 to 14 V
      Table 7. for RHD

      Tester Connection

      Condition

      Specified Condition

      K10-2 (B) - Body ground

      Always

      11 to 14 V

      Standard Resistance

      Table 8. for LHD

      Tester Connection

      Condition

      Specified Condition

      J8-1 (GND) - Body ground

      Always

      Below 1 Ω
      Table 9. for RHD

      Tester Connection

      Condition

      Specified Condition

      K10-1 (GND) - Body ground

      Always

      Below 1 Ω
      Table 10. Text in Illustration

      *1

      for LHD

      *2

      for RHD

      *3

      Front view of wire harness connector

      (to Front Door Window Regulator)

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  6. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

    1. B215963E22

      Remove the power window regulator switch (Click here).

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      6 (UP) - 1 (GND)

      Manual up operation

      Below 1 Ω

      7 (DOWN) - 1 (GND)

      Manual down operation

      Below 1 Ω

    REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY

    (Click here)

  7. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT DOOR WINDOW REGULATOR ASSEMBLY)

    • *1: for LHD

    • *2: for RHD

    1. Disconnect the J4*1 or K4*2 switch connector.

    2. Disconnect the J8*1 or K10*2 regulator connector.

    3. B215964E12

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Table 11. for LHD

      Tester Connection

      Condition

      Specified Condition

      J4-6 (UP) - J8-10 (UP)

      Always

      Below 1 Ω

      J4-7 (DOWN) - J8-7 (DOWN)

      Always

      Below 1 Ω

      J4-6 (UP) or J8-10 (UP) - Body ground

      Always

      10 kΩ or higher

      J4-7 (DOWN) or J8-7 (DOWN) - Body ground

      Always

      10 kΩ or higher
      Table 12. for RHD

      Tester Connection

      Condition

      Specified Condition

      K4-6 (UP) - K10-10 (UP)

      Always

      Below 1 Ω

      K4-7 (DOWN) - K10-7 (DOWN)

      Always

      Below 1 Ω

      K4-6 (UP) or K10-10 (UP) - Body ground

      Always

      10 kΩ or higher

      K4-7 (DOWN) or K10-7 (DOWN) - Body ground

      Always

      10 kΩ or higher
      Table 13. Text in Illustration

      *1

      for LHD

      *2

      for RHD

      *3

      Front view of wire harness connector

      (to Power Window Regulator Switch)

      *4

      Front view of wire harness connector

      (to Front Door Window Regulator)
      Table 14. Result

      Result

      Proceed to

      OK (for LHD)

      A

      OK (for RHD)

      B

      NG

      C

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY RH

    (Click here)

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH

    (Click here)

    REPAIR OR REPLACE HARNESS OR CONNECTOR