MONITOR SYSTEM


  1. FUNCTION OF MAIN COMPONENTS

    Component Function
    Rear Television Camera Assembly Transmits a video signal of the area behind the vehicle to the radio receiver assembly.
    Multi-display Assembly Displays the image transmitted by the rear television camera assembly on the screen.
    Radio Receiver Assembly Displays the images of the area behind the vehicle sent from the rear television camera assembly using the multi-display assembly.
    Shift Lever Position Sensor Transmits the shift position signal to the hybrid vehicle control ECU assembly.
    Hybrid Vehicle Control ECU Assembly Transmits the shift position signal to the radio receiver assembly.
  2. SYSTEM CONTROL


    1. This system operates when both the following conditions have been met:


      • Power switch is on (IG).

      • Shift lever is in R.

  3. FUNCTION


    1. Area Displayed on Screen


      1. Objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.

      2. The rear television camera assembly uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.

        A01O6ZS

        The illustration shown is an example only. The illustration may differ from the actual vehicle screen.

        Note

        The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the rear television camera assembly is limited. The rear television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.

    2. Warning Message


      1. A warning message appears at the bottom of the screen under the following conditions. The warning message appears in the same language that has been selected by the language selector of the multi-display.

        Message Appearing at Bottom of Screen
        Warning Message Condition
        Check surroundings for safety. This message always appears during system operation.
  4. FAIL-SAFE


    1. The table below indicates fail-safe operation when a malfunction is detected:

      Malfunctioning Part Detection Item Function
      Rear Television Camera Assembly Rear television camera assembly malfunction signal is detected. System stops signal reception and displays a dark screen.