CYLINDER HEAD GASKET REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  3. REMOVE EXHAUST MANIFOLD WITH TURBOCHARGER

    Click here

  4. REMOVE CAMSHAFT

    Click here

  5. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

    Click here

  6. REMOVE FUEL INJECTOR SEAL

    Click here

  7. REMOVE GLOW PLUG ASSEMBLY

    Click here

  8. REMOVE CYLINDER HEAD SUB-ASSEMBLY

    1. A273375C01

      Uniformly loosen the 10 bolts in several steps in the sequence shown in the illustration. Remove the 10 cylinder head bolts and 10 plate washers.

      Note:

      Head warpage or cracking could result from removing bolts in the incorrect order.

  9. REMOVE CYLINDER HEAD GASKET