CAMSHAFT OIL CONTROL VALVE(for Intake Side) INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT TIMING GEAR BOLT

    Note

    There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.

    B008MH6C01
    *a Identification Mark
    Identification Mark
    Item Identification Mark
    Type A A
    Type B C

    1. Make sure that the No. 1 cylinder is at the TDC/compression.

      Tech Tips

      Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the protrusion on the timing chain cover assembly.

    2. B008LUL

      Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.

    3. While holding the crankshaft pulley, temporarily install the camshaft timing gear bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the camshaft timing gear bolt has been struck or dropped, replace it.

      • If there is any abnormal resistance when temporarily installing the camshaft timing gear bolt, loosen it and make sure that the No. 1 cylinder is at TDC/compression, and then temporarily install the camshaft timing gear bolt again.

      Tech Tips

      Make sure that the flange part of the camshaft timing gear bolt contacts the entire circumference of the camshaft timing gear assembly.

    4. While holding the crankshaft pulley, loosen the camshaft timing gear bolt 60 to 180°.

    5. Turn the crankshaft pulley clockwise 70 to 110°.

    6. While holding the crankshaft pulley, tighten the camshaft timing gear bolt.

      Torque:
      for Type A
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }
      for Type B
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

      Note

      Do not use an impact wrench.

  2. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side)

    Click here

  3. INSPECT FOR ENGINE OIL LEAK

    Click here