REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:
    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

  3. REMOVE REAR ARMREST ASSEMBLY LH

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

  6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

  7. REMOVE REAR DOOR SERVICE HOLE COVER LH

  8. REMOVE REAR DOOR GLASS RUN LH

  9. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

  10. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

  12. REMOVE REAR DOOR BELT MOULDING LH

    B241010C01

    *1

    Protective Tape

    1. Detach the 7 claws and remove the rear door belt moulding.