ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. REMOVE MANUAL TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE CLUTCH COVER ASSEMBLY


    1. B007VZ5E01

      Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

    2. Loosen each set bolt one turn at a time until spring tension is released.

      Note

      Do not drop the clutch disc assembly.

    3. Remove the set bolts, and pull off the clutch cover assembly.

  3. REMOVE CLUTCH DISC ASSEMBLY

    Note

    Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.

  4. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. B007QHDE01

      Fix the crankshaft with SST, then remove the 8 bolts and flywheel.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021

  5. REMOVE REAR END PLATE


    1. Remove the 2 bolts and rear end plate.

  6. REMOVE FLYWHEEL HOUSING DUST SEAL


    1. Remove the flywheel housing dust seal.

  7. REMOVE ENGINE REAR OIL SEAL


    1. B007VRKE02

      Using a knife, cut off the oil seal lip.

    2. Using a screwdriver, pry out the oil seal.

      Note

      After the removal, check that the crankshaft is not damaged. If damaged, mend it with a sandpaper (#400).