FRONT BUMPER(for Hatchback, Wagon) REMOVAL

PROCEDURE

  1. REMOVE FRONT SPOILER PROTECTOR

    Click here

  2. REMOVE FRONT BUMPER ASSEMBLY

    1. B410073C01
      V100155

      Protective Tape

      Apply protective tape around the front bumper assembly as shown in the illustration.

    2. B403546C03

      *1

      Pin Hold Clip

      *a

      90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tip:

      Use the same procedure for the RH side and LH side.

    3. Remove the clip.

      Tip:

      Use the same procedure for the RH side and LH side.

    4. B410074

      Remove the 6 screws.

    5. B410075

      Disengage the 3 claws as shown in the illustration.

      Tip:

      Use the same procedure for the RH side and LH side.

    6. w/ Fog Light:

      1. Pull back the side of the front bumper assembly and disconnect the 2 fog light connectors.

        Note:

        Do not apply excessive force when pulling back the side of the front bumper assembly.

    7. B410077

      Remove the bolt.

    8. Using a clip remover, remove the 2 clips.

    9. w/ TOYOTA Parking Assist-sensor System:

      1. Disconnect the ultrasonic sensor connector.

    10. w/ Headlight Cleaner System:

      1. Disconnect the headlight cleaner hose and drain the washer fluid.

        Tip:

        Use a container to collect the washer fluid.

    11. Remove the front bumper assembly as shown in the illustration.