AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System), Diagnostic DTC:B130C
| DTC Code | DTC Name |
|---|---|
| B130C | Left Sunlight Probe Fault |
DESCRIPTION
The cooler (solar sensor) thermistor is installed on the upper side of the instrument panel. It detects sunlight to control air conditioning control in AUTO mode. The output voltage from the cooler (solar sensor) thermistor varies in accordance with the amount of sunlight. When the sunlight increases, the output voltage increases. As the sunlight decreases, the output voltage decreases. The air conditioning control assembly detects changes in the output voltage from the cooler (solar sensor) thermistor.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
B130C |
Left Sunlight Probe Fault |
Short in cooler (solar sensor) thermistor circuit |
|
WIRING DIAGRAM
PROCEDURE
CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL ASSEMBLY - COOLER (SOLAR SENSOR) THERMISTOR)
Disconnect the E54 air conditioning control assembly connector.
Disconnect the F1 cooler (solar sensor) thermistor connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
E54-2 (S5-1) - F1-1 (SS+)
Always
Below 1 Ω
E54-3 (TSD) - F1-2 (SS-)
Always
Below 1 Ω
E54-2 (S5-1) - Body ground
Always
10 kΩ or higher
E54-3 (TSD) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
REPLACE COOLER (SOLAR SENSOR) THERMISTOR
Replace the cooler (solar sensor) thermistor.
Tip:Since the cooler (solar sensor) thermistor cannot be inspected while it is removed from the vehicle, replace the cooler (solar sensor) thermistor with a new or known good one and check that the condition returns to normal.
When troubleshooting according to the DTC.
Check for DTCs.
Body Electrical > Air Conditioner > Trouble Codes
When troubleshooting according to Problem Symptoms Table.
OK
Malfunction disappears.
Result
Result
Proceed to
DTC B130C is output (When troubleshooting according to the DTC)
A
NG (When troubleshooting according to Problem Symptoms Table)
B
DTC B130C is not output (When troubleshooting according to the DTC)
C
OK (When troubleshooting according to Problem Symptoms Table)
C END (COOLER (SOLAR SENSOR) THERMISTOR WAS DEFECTIVE)