REAR ACCELERATION SENSOR REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereClick hereClick here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick hereClick here).

  2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    1. Remove the deck trim side panel assembly LH (Click hereClick hereClick hereClick here).

  3. REMOVE REAR ACCELERATION SENSOR

    1. C213603

      Disconnect the connector.

    2. Remove the bolt and rear acceleration sensor.

      Note:

      Replace the rear acceleration sensor with a new one if it is dropped.