BLIND SPOT MONITOR SENSOR INSTALLATION

PROCEDURE

1. INSTALL BLIND SPOT MONITOR SENSOR LH

   Note:

   • Avoid any impact to the blind spot monitor sensor LH.

   • Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.

   1. Connect the connector.

   2. Install the blind spot monitor sensor LH with the 3 nuts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

2. INSTALL BLIND SPOT MONITOR SENSOR RH

   Note:

   • Avoid any impact to the blind spot monitor sensor RH.

   • Do not drop the blind spot monitor sensor RH. If it is dropped, replace it with a new one.

   1. Connect the connector.

   2. Install the blind spot monitor sensor RH with the 3 nuts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

3. INSTALL REAR BUMPER COVER

   Click hereClick here

4. INSTALL REAR QUARTER PANEL MUDGUARD LH (w/ Mudguard)

   Click hereClick here

5. INSTALL REAR QUARTER PANEL MUDGUARD RH (w/ Mudguard)

   Tip:

   Use the same procedure described for the LH side.

6. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

   Click here

7. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here