CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL NO. 1 CRANK POSITION SENSOR

   1. for Intake side:

      1. 

         *1

         O-ring

         Apply a light coat of engine oil to the O-ring of the sensor.

         Note:

         If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Install the No. 1 crank position sensor to the cylinder head cover sub-assembly with the bolt.

         10 N*m

         102 kgf*cm

         7 ft.*lbf

         Note:

         • If a component has been dropped or subjected to a strong impact, replace it.

         • Make sure that the O-ring is not damaged or does not jump out of position during installation.

      3. Connect the No. 1 crank position sensor connector.

   2. for Exhaust side:

      1. 

         *1

         O-ring

         Apply a light coat of engine oil to the O-ring of the sensor.

         Note:

         If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Install the No. 1 crank position sensor to the cylinder head cover sub-assembly with the bolt.

         10 N*m

         102 kgf*cm

         7 ft.*lbf

         Note:

         • If a component has been dropped or subjected to a strong impact, replace it.

         • Make sure that the O-ring is not damaged or does not jump out of position during installation.

      3. Connect the No. 1 crank position sensor connector.

2. INSPECT FOR ENGINE OIL LEAK

3. INSTALL NO. 2 CYLINDER HEAD COVER

   Click hereClick hereClick hereClick here