FLOOR SHIFT ASSEMBLY ADJUSTMENT


  1. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

    2. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves in reverse after shifting to R.

      If the results are not as specified, inspect the park/ neutral position switch and check the shift lever.

  2. ADJUST SHIFT LEVER POSITION


    1. Move the shift lever to N.

    2. A01DZUZE02

      Remove the nut and disconnect the control cable.

    3. A01DUXDE01

      Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

    4. While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }