RADIO RECEIVER REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

   Click here

4. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

   Click here

5. REMOVE CONSOLE ARMREST ASSEMBLY

   Click here

6. REMOVE UPPER REAR CONSOLE PANEL

   Click here

7. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

   Click here

8. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

   Click here

9. REMOVE INSTRUMENT SIDE PANEL RH

   Click here

10. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

11. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

12. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

13. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

14. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

15. REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

16. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

17. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

18. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

    Click here

19. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

    Click here

20. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    
    

    1. 

       Remove the 2 bolts.

    2. Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.

    3. Disconnect each connector and remove the radio receiver assembly with bracket.

21. REMOVE NO. 1 RADIO BRACKET

    
    

    1. 

       w/ Navigation System

       
       

       1. Remove the 3 screws and No. 1 radio bracket.

    2. 

       w/o Navigation System

       
       

       1. Remove the 3 screws and No. 1 radio bracket.

22. REMOVE NO. 2 RADIO BRACKET

    
    

    1. 

       w/ Navigation System

       
       

       1. Remove the 3 screws and No. 2 radio bracket.

    2. 

       w/ Navigation System

       
       

       1. Remove the 3 screws and No. 2 radio bracket.

23. REMOVE RADIO RECEIVER ASSEMBLY