FUEL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL FUEL PUMP WITH FILTER ASSEMBLY

    Tech Tips

    Perform "Inspection After Repair" after replacing the fuel pump with filter assembly.

    Click here


    1. A01O9HDC02
      *1 O-ring
      *2 Fuel Pump Spacer

      Apply a light coat of gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump with filter assembly.

    2. Engage the 5 claws to install the fuel pump with filter assembly to the fuel filter.

      Note


      • Make sure that the O-ring is not cut or pinched during installation.

      • Make sure the claws are engaged securely.

      • Do not remove the fuel filter.

  2. INSTALL NO. 1 FUEL SUCTION SUPPORT


    1. Engage the 2 claws to install the No. 1 fuel suction support to the fuel filter.

  3. INSTALL FUEL PUMP HARNESS


    1. Install the fuel pump harness connector to the fuel pump with filter assembly.

  4. INSTALL JET PUMP


    1. Apply a light coat of gasoline to a new O-ring and install the O-ring to the jet pump.

    2. A01OACVC03
      *1 O-ring
      *a Notch

      Install the jet pump to the No. 1 fuel sub-tank as shown in the illustration.

      Note

      Make sure that the O-ring is not cut or pinched during installation.

    3. Engage the claw and install the fuel tube to the No. 1 fuel sub-tank.

      Note

      Securely engage the claw.

  5. INSTALL FUEL FILTER


    1. Engage the 2 claws to install the fuel filter and fuel pump with filter assembly to the No. 1 fuel sub-tank.

      Note


      • Do not apply excessive force to the tube or No. 1 fuel suction support.

      • Securely engage the claws.

  6. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY


    1. Install the spring to the fuel suction plate shaft.

    2. Install the fuel suction plate sub-assembly to the No. 1 fuel sub-tank.

    3. Install a new E-ring to the fuel suction plate shaft.

    4. Connect the fuel pump harness connector.

      Note

      Make sure that the fuel pump harness connector is connected securely.

    5. A01ODV9N01

      Engage the clamp to connect the fuel pump harness to the fuel suction plate sub-assembly as shown in the illustration.

      Note


      • Engage the connector (A) first and then (B) when connecting the fuel pump harness to the clamp.

      • Do not twist or excessively pull the fuel pump harness.

  7. INSTALL FUEL SENDER GAUGE ASSEMBLY

    Click here