REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL REAR SPEED SENSOR LH


    1. B006DVR

      Install the rear speed sensor LH with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • The rear speed sensor is easily damaged. When installing the rear speed sensor to the rear axle hub LH, do not use excessive force to rotate and install it.

      • Prevent foreign matter from attaching to the sensor tip.

      • Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.

  2. INSTALL SKID CONTROL SENSOR WIRE


    1. B006AMF

      for LH Side:


      1. Install the sensor clamp with the bolt.

        Torque:
        8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

        Note

        Do not twist the skid control sensor wire.

      2. Connect the speed sensor connector to the rear speed sensor LH.

    2. B006FS9

      for RH Side:


      1. Install the sensor clamp with the bolt.

        Torque:
        8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

        Note

        Do not twist the skid control sensor wire.

      2. Connect the speed sensor connector to the rear speed sensor RH.

      3. Connect the pad wear indicator connector.

    3. B006ESE

      Install the 3 sensor clamps with the 3 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      Do not twist the skid control sensor wire.

    4. Connect the rear height control sensor connector.

    5. Connect the absorber control actuator connector.

    6. B006CCZ

      Insert the 2 skid control sensor wire connectors into the cabin from the hole in the rear wheel house.

    7. Attach the 2 grommets to the hole in the rear wheel house.

    8. B006FHL

      for LH Side:


      1. Connect the 2 cabin skid control sensor wire connectors.

    9. B006B51

      for RH Side:


      1. Connect the 2 cabin skid control sensor wire connectors.

  3. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LH

    Click here

  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER RH

    Click here

  5. INSTALL REAR WHEEL

    Click here

  6. CHECK FOR SPEED SENSOR SIGNAL

    Click here