ENGINE UNIT REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine assembly disassembly/reassembly are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

  • Replacement of camshaft timing gear assembly

  • Replacement of camshaft timing exhaust gear assembly

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE TURBOCHARGER SUB-ASSEMBLY

    Click here

  2. REMOVE FUEL INJECTOR ASSEMBLY

    Click here

  3. REMOVE FUEL PUMP ASSEMBLY

    Click here

  4. REMOVE NO. 1 IGNITION COIL

    Click here

  5. REMOVE FUEL VAPOR FEED PIPE


    1. B008KX5

      Remove the 2 bolts and fuel vapor feed pipe from the cylinder head cover sub-assembly.

  6. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY


    1. B008LH1

      Remove the water by-pass pipe union bolt and water inlet pipe gasket.

    2. Remove the 3 bolts and water by-pass pipe sub-assembly from the cylinder head sub-assembly.

  7. REMOVE VACUUM PUMP ASSEMBLY

    Click here

  8. REMOVE NO. 1 WATER BY-PASS HOSE


    1. B008MI8

      Slide the clip and remove the No. 1 water by-pass hose from the water inlet.

  9. REMOVE NO. 1 HEAT INSULATOR BRACKET


    1. B008KDF

      Remove the bolt and No. 1 heat insulator bracket from the cylinder block sub-assembly.

  10. REMOVE WIRE HARNESS CLAMP BRACKET


    1. B008LSP

      Remove the 3 bolts and 2 wire harness clamp brackets from the cylinder head cover sub-assembly.

    2. B008MCD

      Remove the bolt and wire harness clamp bracket from the cylinder head sub-assembly.

    3. B008M8C

      Remove the 3 bolts and 2 wire harness clamp brackets from the stiffening crankcase assembly.

    4. B008K67

      Remove the bolt and wire harness clamp brackets from the stiffening crankcase assembly.

    5. B008LBL

      Remove the 2 bolts and wire harness clamp bracket from the timing chain cover assembly.

  11. REMOVE DRIVE SHAFT BEARING BRACKET (for AWD)


    1. B008K8N

      Remove the 3 bolts and drive shaft bearing bracket from the stiffening crankcase assembly.

  12. REMOVE STUD BOLT


    1. B008MD5

      Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the timing chain cover assembly.