TIRE PRESSURE WARNING RECEIVER(for LH Side) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

    Tech Tips

    The installation location of the tire pressure warning receiver differs depending on the vehicle. For more details about the installation location, refer to the following.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR SEAT ASSEMBLY


  4. REMOVE TONNEAU COVER ASSEMBLY

    Click here

  5. REMOVE DECK BOARD ASSEMBLY

    Click here

  6. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

  8. REMOVE REAR DECK FLOOR BOX

    Click here

  9. REMOVE SPARE TIRE

  10. REMOVE DECK FLOOR BOX LH

    Click here

  11. REMOVE DECK FLOOR BOX RH

    Click here

  12. REMOVE NO. 1 TOOL BOX SUB-ASSEMBLY

    Click here

  13. REMOVE NO. 2 TOOL BOX SUB-ASSEMBLY

    Click here

  14. REMOVE REAR FLOOR FINISH PLATE

    Click here

  15. REMOVE BATTERY SERVICE COVER BOARD


  16. REMOVE NO. 1 SEAT LEG ASSEMBLY


  17. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  18. REMOVE ROPE HOOK ASSEMBLY

    Click here

  19. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  20. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  21. REMOVE UPPER DECK TRIM SIDE BOARD LH

    Click here

  22. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  23. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  24. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER


    1. B008ISL

      Remove the bolt.

    2. Detach the 2 guides to remove the tire pressure warning ECU and receiver.

    3. Disconnect the connector from the tire pressure warning ECU and receiver.