STEERING HEATER SWITCH INSPECTION

PROCEDURE

  1. INSPECT STEERING HEATER SWITCH

    1. Disconnect the steering heater switch connector.

    2. C233764C07

      *a

      Component without harness connected

      (Steering Heater Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      6 (IG) - 3 (B)

      Steering heater switch is pushed

      Below 1 Ω

      6 (IG) - 3 (B)

      Steering heater switch is not pushed

      10 kΩ or higher

      If the result is not as specified, replace the steering heater switch.