MANUAL TRANSAXLE ASSEMBLY COMPONENTS
ILLUSTRATION
*A |
Type A |
*B |
Type B |
*1 |
ENGINE ASSEMBLY WITH TRANSAXLE |
*2 |
FRONT ENGINE MOUNTING INSULATOR |
*3 |
REAR ENGINE MOUNTING INSULATOR |
*4 |
SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY |
*5 |
O-RING |
*6 |
WIRE HARNESS |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
 |
Gear oil |
- |
- |
ILLUSTRATION
*1 |
CLUTCH FLEXIBLE HOSE BRACKET |
*2 |
CLUTCH RELEASE BLEEDER SUB-ASSEMBLY |
*3 |
BLEEDER CLUTCH RELEASE TUBE |
*4 |
CLUTCH RELEASE CYLINDER TO BLEEDER TUBE |
*5 |
CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY |
*6 |
ENGINE MOUNTING BRACKET LH |
*7 |
FRONT ENGINE MOUNTING BRACKET |
*8 |
MANUAL TRANSAXLE ASSEMBLY |
*9 |
REAR ENGINE MOUNTING BRACKET |
*10 |
STARTER ASSEMBLY |
*11 |
WIRE HARNESS CLAMP BRACKET |
*12 |
CLUTCH TUBE BOOT |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
Clutch spline grease |
 |
Adhesive 1324 |
★ |
Precoated part |
- |
- |
*T1 |
Bolt Length 25 mm (0.984 in.): 45 (459, 33) Bolt Length 22 mm (0.866 in.): 64 (653, 47) |
- |
- |