EXHAUST PIPE GAS CONTROL ACTUATOR INSTALLATION

PROCEDURE

1. INSTALL EXHAUST PIPE GAS CONTROL ACTUATOR

   1. 

      *1	Exhaust Pipe Gas Control Stopper
      *2	Exhaust Pipe Gas Control Actuator Case
      *3	Exhaust Pipe Gas Control Actuator
      *4	O-ring
      *5	Piston

      Apply engine coolant to the O-ring.

   2. Install the exhaust pipe gas control actuator and exhaust pipe gas control stopper.

      Note:

      • Be sure to install the exhaust pipe gas control stopper in the correct direction.

      • Check that the O-ring is not deformed, cracked or swollen.

      • Be sure to install the exhaust pipe gas control actuator until it touches the exhaust pipe gas control stopper.

      • When installing the exhaust pipe gas control actuator, do not push on the piston.

      • Make sure that the exhaust pipe gas control actuator and the exhaust pipe gas control stopper are free of oil.

   3. 

      *1

      Gasket

      Install a new gasket and the exhaust pipe gas control actuator case with the 3 bolts and 3 nuts.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

      Note:

      • Be sure to install the gasket in the correct direction.

      • Make sure that the exhaust pipe gas control actuator case and the gasket are free of oil.

   4. 

      *1	Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, pry the portion shown in the illustration to engage the spring.

   5. Connect the 2 water hoses and slide the 2 clips to secure them.

2. ADD ENGINE COOLANT

   Click here

3. INSPECT FOR COOLANT LEAK

   Click here

4. INSTALL NO. 1 ENGINE UNDER COVER

   Click here