ВЫПУСКНАЯ ТРУБА СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front exhaust pipe assembly, center exhaust pipe assembly (TWC: Rear Catalyst) and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B006O6C

PROCEDURE


  1. REMOVE TAIL EXHAUST PIPE ASSEMBLY

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01IKC0

      Remove the 2 bolts, 2 compression springs and tail exhaust pipe assembly from the center exhaust pipe assembly (TWC: Rear Catalyst).

    2. Disconnect the tail exhaust pipe assembly from the 3 exhaust pipe supports.

    3. Remove the exhaust pipe gasket from the center exhaust pipe assembly (TWC: Rear Catalyst).

  2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01IL5J

      Remove the 2 bolts and center exhaust pipe assembly (TWC: Rear Catalyst) from the front exhaust pipe assembly.

    2. Disconnect the center exhaust pipe assembly (TWC: Rear Catalyst) from the 3 exhaust pipe supports.

    3. Remove the exhaust pipe gasket from the front exhaust pipe assembly.

  3. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01IKTS

      Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).

    2. Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).

  4. REMOVE HEATED OXYGEN SENSOR

    Click here